Henri PLC programmer

HenRi Programmable Controller xc Ladder Programmer xctool.exe 1.3m

Remote programming tool: loader.exe 1M

Note: All of the upper two program should be installed ,otherwise the XC programmer can not work correctly.

Examples:

(The following examples could help you to learn the PLC programming in a short time .You should download and install the programmer at first ,otherwise ,you can't open these example files.)

1:THE SHORTEST LADDER PROGRAM:

download

This program use input In0 to control output Out0.It's very simple ,but you can learn more basic knowledge from it.

Open the file ,click the button ,you would see nothing changed at this time ,but the color of the left IN0 changed to green from red when clicked by you .The simulation state of green color means closed and the red color means open .The right OUT0 changed to green from red at the same time ,means closed also.

The input simulation mode selection dialog box would be popped up when you right click the input IN0.The In0 would flash in red and green color at 10Hz frequency when you select the 10Hz pulse mode .The Out0 state is same as In0 according to the ladder program.

2:Traffic Red-Green indicator:

download

Open the file ,click the button, ,the outputs OUT0,OUT1,OUT2 will flash one by one .This example descripes how to generate a pulse output using HenRi PLC.

3:Angle-Star motor start program:

download

This program is explained in the hardware manual.

4：A mechanical control system

download

The system is widely used in small mechanical control. It has alarm, precise counter, start and stop, inch foreword and inverse functions. It is explained in the hardware manual.